![]() This is to load the initial project on the Homeserver via a Serial Connection. Why does is starts (and ends) the hs_trans program ? A. – Then it starts the hs_main (also Gira propriatary software) which is the main program. – It starts the hs_trans (Gira propriatary software) which automatically ends after a few seconds. The start.sh script does actually two things: When starting the homeserver, the vmlinuz from the Boot partition is loaded (via loadlin / DOS) and it boots the system into a Linux kernel, then a /etc/inittab startup script calls the /hs/bin/start/start.sh script. The boot process and hs_trans and hs_main programs /dev/hdc3 (21MB) – (used to store the project?)./dev/hdc2 (20MB) – Linux/Operating System, mountpoint: /./dev/hdc1 (2MB) – Boot partition with vmlinux (kernel) and loadlin.Some Gira proprietary Software (hs_trans and hs_main executables)Īfter some research I also found the following:Ī Flash drive is connected as a Master on the second IDE ATA controller (which means it is /dev/hdc) and exists of 4 partitions:.A ISDN adapter (We don’t use that anymore in 2009, everybody is calling VOIP ) ). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |